We service both gas and electric furnace systems with manufacturer-trained technicians.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
Our technicians treat every furnace repair call in Palo Alto, CA the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
No-heat calls during freeze warnings get moved to the front of the schedule.
From the first symptom to the final fix, these are the specific furnace repair services our Palo Alto-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Palo Alto, CA.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Palo Alto, CA.
We use a combustion analyzer and visual borescope inspection, not guesswork. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Palo Alto, CA.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Palo Alto, CA.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Gas odor reports get immediate safety instructions before dispatch details.
We confirm your Palo Alto address and a realistic arrival window.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Palo Alto, CA to keep response times realistic, not just promised.
☎ Call +1-844-611-2875 for Palo Alto Service